We often get asked to restore old Victorian tiled floors which are generally over 100 to 150 years old and as I’m sure you can imagine they experience a lot of wear over that length of time.
We recently visited a property with such a floor in Lancaster after the client got in touch looking to have their hallway floor tiles restored. We arrived to inspect the floor and could see straight away that it was looking a little tired and in need of care and attention. Some tiles had become loose and had broken apart, especially around the doorways. Also, this floor had suffered from subsidence in the past and this had created a crack line near the top end of the hallway which pushed up several of the tiles. We went through what could be done to restore it, the client agreed a price and we arranged a time to come back.
Cleaning and Repairing a Victorian Tiled Hallway Floor
My first task was to take the loose tiles up, grind the concrete screed back so it was as level as we could make it and then we needed to refit the tiles. Once all loose tiles were fixed, we left them to dry and cure.
We then came back to start the main clean of the floor, we used Tile Doctor Diamond Burnishing pads for this, which bite in deep to the clay face and remove ingrained dirt far better than conventional alkaline cleaners can. We used a series of different grades of these diamond pads to get the finish we required and then rinsed with clean water once were finished, removing the slurry created with a wet vacuum.
Any areas we couldn’t reach with our weighted buffing machines we had to get on our hands and knees and use small handheld Diamond Blocks, using a bit of clean water and elbow grease, this is especially good on intricate edges and around doors and corners.
The floor was given a quick rinse with water to remove any remaining clay resin and soil generated by the burnishing process. A wet vacuum is then used to extract the soil and remove as much moisture from the floor before being left to dry off fully overnight.
Sealing a Victorian Tiled Hallway Floor
Before we seal the Victorian Tiles, they looked very dull and washed out however this all changes once we apply the sealer. We checked the moisture levels in the floor which were fine. Our favourite sealer for this type of tile is called Tile Doctor Colour Grow, this is a fully breathable sealer which restores the colour lost in the cleaning process and allows for the floor to breathe, which is an absolutely necesity on an old floor without a Damp Proof Membrane where Efflorescence can be an problem.
Tile Doctor Colour Grow is an impregnating sealer that works by occupying the pores in the tile, so dirt cannot become ingrained there. It leaves a matt finish and enhances the colours in the tile bringing them to life, as you will see on the photos.
For aftercare we always advise our customers to use Tile Doctor pH Neutral tile cleaner as it’s specially designed for cleaning sealed surfaces without damaging the sealer like cheap supermarket cleaners that contain anionic surfactants.
The client was very pleased with the restoration of her floor which is now in good physical condition and looks much brighter.